IEC 61000 4 5 Surge Generator Working Principle

 IEC 61000 4 5 Surge Generator Working Principle


Surges are a key problem in electronics since they are every circuit developer’s biggest concern. These surges are usually referred to as impulses, which have the distinct  IEC protection Class for LED luminaires

characteristics of high voltages, typically in the kV range, that remain for a brief period. The features of an impulse voltage may be identified by a high or low fall time followed by a very high voltage increase time. An example of impulse voltage from a natural cause can be lightning. Let’s find out more about the working principal of the unit. Read on to find out more.

Since this impulse voltage may appear to be extremely harmful to electrical equipment, it is crucial to test the gadgets to ensure that they can withstand it. This is where a surge generator, which creates high voltage or current surges, comes in handy.

Basic Working Principle

The EC 61000-4-5 standard specifies the immunity criteria, test methodologies, and the range of standard testing levels for equipment against unidirectional surges generated by overvoltage from switching and lightning transients. The testing levels for electrical and electronic equipment are determined depending on the environment and installation circumstances. The primary goal of this standard is to create a consistent reference for measuring the resistance of electrical and electronic equipment to surges.

Surge Protection IEC 61000-4-5 Immunity stress is intended to be indicative of voltage or current pulses that are generated on power networks by events that occurred outside of the equipment under test. Surges can be caused by power system switching transients, such as capacitor bank switching or load shifts. Surges on electrical lines could also be caused by lightning, either as a direct hit to a transmission line or as a result of a surrounding lightning strike.

A surge generator is used to accomplish the capacitor discharge technique. This equipment transforms line power into high voltage, unidirectional impulses, which are then sent through a faulty power connection. Capacitor charges are proportional to the voltage of the power supply. When the switch is closed, the capacitor discharges a high voltage impulse into the cable under test. Upon analyzing the findings, the curve illustrates how time influences the voltage at which a gap will flash over.



Leave a Reply

Your email address will not be published.